ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller. The ESP32 is integrated with Antenna switches, RF Balun, power amplifiers, low-noise amplifiers, filters, and management modules, and the entire solution occupies the least area of PCB. 2.4 GHz Wi-Fi plus Bluetooth dual-mode chip, with TSMC Ultra-low power consumption 40nm technology, power dissipation performance, and RF performance is the best, safe and reliable, easy to extend to a variety of applications. RoboticsBD
Features:
- High performance-price ratio
- Small volume, easily embedded to other products
- Strong function with support LWIP protocol, Freertos
- Supporting three modes: AP, STA, and AP+STA
- Supporting Lua program, easily to develop
Specification:
- 2.4GHz Dual-Mode WiFi + Bluetooth Development Board, 38PIN
- Ultra-Low power consumption works perfectly with the IDE
- Support LWIP protocol, Freertos
- SupportThree Modes: AP, STA, and AP+STA
- ESP 32 is safe, reliable, and scalable to a variety of applications
| General Specification |
| Processor |
Dual-core 32-bit processor, operating at a frequency of 80, 160 or 240 MHz |
| RAM |
520 KB |
| Flash memory |
448 KB |
| Power Supply |
2.2-3.6 V |
| ADC 12-bit |
18 |
| DAC 8-bit |
2 |
| Temperature sensor |
Built in |
| SPI |
4 |
| I2S |
2 |
| I2C |
2 |
| UART |
3 |
| Ethernet controller |
Yes |
| CAN |
2.0 |
| Hall Sensor |
Built in |
| Shipment Weight |
0.091 kg |
| Shipment Dimensions |
10 × 7 × 3 cm |
Documentation:
Installation:
- 1. Download the Arduino IDE
- Install Git from the site
- Run Git GUI
- Select Clone Existing Repository
- In the Source Location write https://github.com/espressif/arduino-esp32.git
- In the Target Directory write C:/Users / [USERNAME]/Documents/Arduino/hardware/espressif / esp32
- Click Clone
- Open the directory C:/Users / [USERNAME]/Documents/Arduino/hardware/espressif/esp32 / tools and run the file get.exe
- Connect our Board
- If the drivers themselves are not installed, then install the driver for CP210x (I had CP2102) from here
- Run the Arduino IDE
- Select the cost in the Tools > Board (Tools > Board) (I DOIT ESP32 DEVKIT V1)
- Select the COM port to which the Board is installed
- How to identify a port?
- Open device Manager
- Open the group "Ports (COM & LPT)"
- Look the name of the device. There must be something like that among them Meet ESP32, part 1: installing the Arduino IDE ESP32, arduino, instruction, first run, dinobot COM7 - this is our port.
- Select any example (for example, here)
- Load by pressing Ctrl + U
- Some instructions say that you need to press the BOOT button on the Board during boot. (Check)
Package Includes:
1 x ESP32 38Pin Development Board
