Reference: RBD-1727

IR Infrared Transmitter Module

3 reviews

This is 38KHz Infrared IR transmitter sensor module For Arduino Transmit 38KHz modulating signal Suitable for Arduino DIY project Material: PCB

Reference: RBD-3042

IFM KB5096 KB-3020-APKG/NI/US-100-DPO Capacitive Sensor

High noise immunity with easy sensing range adjustment via potentiometer. Cylindrical smooth plastic housing protects against deposits and harsh environments. PNP normally closed output with a 20mm adjustable sensing range. Short-circuit, reverse polarity, and overload protection for enhanced reliability. Suitable for position detection or level...

Reference: RBD-2678

Surface Transducer - Large

1 review

Surface transducers give you the awesome power to turn almost any surface into a speaker. They're essentially just a speaker except instead of a cone, the coil is attached to a pad that conducts the vibration into whatever you press it against. Hook it up to an audio source and press it against the nearest table, wall or cardboard box. You can even put it...

Reference: RBD-1424

ZMCT103C 5A Range Single Phase AC Micro Current Transformer Sensor

Onboard precision microcurrent transformer. Onboard sampling resistor. The module can measure AC currents less than 5A, the corresponding analog output 5A/5mA. Rated input current: 5A Rated output current: 5mA Change: 1000: 1 The linear range: 0 ~ 10A (100 ohms) Linearity: 0.2%

Reference: RBD-0334

9 Degrees of Freedom Breakout- MPU9150

1 review

The 9DOF MPU-9150 is the world’s first 9-axis MotionTracking MEMS device designed for the low power, low cost, and high performance requirements of consumer electronics equipment including smartphones, tablets and wearable sensors. And guess what? You get to play with it.

Reference: RBD-3244

Brand: DFRobot

Industrial pH Electrode - Armor Casing Haoshi H101

The Industrial pH Electrode - Armor Casing (H-101) is a high-performance pH combination electrode designed for precision and durability in industrial applications. It features a low-impedance sensitive glass membrane, ensuring fast response and excellent thermal stability. The electrode is robust, with a ring PTFE membrane that resists clogging, making it...

Reference: RBD-1199

Hall Effect Sensor A1302 49E

5 reviews

Low-noise output Fast power-on time Ratiometric rail-to-rail output 4.5 to 6.0 V operation Solid-state reliability Factory-programmed at end-of-line for optimumperformance Robust ESD performance 

Reference: RBD-0357

GY-ML8511 Ultraviolet Light UV Sensor Module

3 reviews

Operating voltage (VCC): 3 V to 5V Operating current: 120μA (typical) 190μA (max) Operating Temperature: -40°C ~ +85°C Photodiode sensitive to UV-A and UV-B Embedded operational amplifier Analog voltage output Low supply current (300uA type) and low standby current (0.1uA type) RoboticsBD

Reference: RBD-1204

SHARP Distance Measuring Sensor GP2Y0A710K0F

1 review

Distance measuring range: 100 cm to 550 cm Output type: Analog voltage Output voltage differential over distance range: 2.05 V (typical) Update period: 38 ± 10 ms

Reference: RBD-1836

Non-invasive AC current Sensor Split Core Current Transformer SCT-013-000 30A

2 reviews

Input Current : 0-30A Output Mode: 0-1V @ 30mA Frequency: 50HZ-150KHZ Opening Size: 13 x 13mm/ 0.5″ x 0.5″(L*W) Output Plug 3.5mm Dielectric Strength 6000V AC/1min Suitable for lighting equipment, AC motors, air compressors, monitoring, current measurement, and protection Meet UL94-V0 flame retardant properties

Reference: RBD-2099

Touch Sensor Switch Module

1 review

Main chip: LM393 Working voltage: for DC 5V Single-channel signal output Low-level output signal used for human body touch sensor alarm Adjustable sensitivity Pin Connector to board: 4 Pins

Reference: RBD-2729

SGP41 Air Quality Digital TVOC Detection Sensor

1 review

The SGP41 from Sensirion is an innovative VOC and NOx sensor engineered to serve as a digital smart switch and regulation unit in air treatment systems like air purifiers. Utilizing Sensirion's advanced Gas Index Algorithm, the sensor accurately processes two distinct signals, enabling automatic triggering of air treatment devices for the removal of...

Reference: RBD-2229

Piezoelectric Vibration Sensor Module with Analog & Digital Output

2 reviews

Highly sensitive and reliable Piezoelectric Vibration Sensor Module Detects vibration and measures acceleration Analog and digital outputs Suitable for industrial control systems, robotics, automotive, and consumer electronics

Reference: RBD-0338

Brand: Waveshare

Dust Sensor For Arduino

Sharp GP2Y1010AU0F onboard, Detecting fine particle larger than 0.8μm  Low power consumption Analog voltage output The output level is linear with dust density Check out New Product Optical Dust Sensor- GP2Y1010AU0F

Reference: RBD-2835

Explosive Gas Sensor Figaro TGS813-A00 Original

The sensor has high sensitivity to gases such as methane, propane, butane and hydrogen. The supply voltage is 24 V. Measuring range is up to 10,000 ppm.

Reference: RBD-0415

801S Vibration Sensor Module

3 reviews

Has a signal output instruction When the output valid signal is high, the light goes out The sensitivity is adjustable (fine-tuning) The wide detection range of vibration, no direction With mounting holes, firmware installation is flexible and convenient. RoboticsBD

Reference: RBD-2790

Hall-Effect Sensor - US1881 (Latching)

The US1881 is an integrated Hall-Effect latched sensor. That's nice but what does it do? Holding a magnet near the sensor will cause the output pin to toggle. This makes for a robust presence sensor. A reed sensor also works nicely, but can be limited by the glass encapsulation and size. A Hall-Effect sensor is much smaller, but can handle less current...

Reference: RBD-2960

XKC-Y26 NPN 24V Intelligent Non-Contact Liquid Level Sensor Water Level Sensor

Model:XKC-Y26 NPN Input Voltage (V): 24 Current Consumption (mA):5 Max Output Current (mA):1~100 Response Time:500mS

Reference: RBD-1177

4-20mA Signal Generator Current Loop Simulator Tester

1 review

This signal generator can use 4-20mA to generate voltage and control the current in the circuit. Accuracy up to 0.01; Liquid crystal display; Rotary encoder adjustment ; Two connection terminals are non polarity. Output range can be set; 4-20mA (device control) / -21mA (signal debugging) Display mode can be set, it is convenient for you to see the value...

Reference: RBD-1211

CJMCU-101 OPT101 Analog Light Sensor Intensity Module

2 reviews

Single supply: 2.7-36v Size of photodiode: 2.29mm x 2.29mm Internal feedback resistor: 1MΩ

Reference: RBD-0673

MQ-4 Methane Natural Gas Sensor

10 reviews

Detecting range: 300~10000ppm Signal output indicator. Dual Signal output (analog output and TTL output). The TTL output signal is low level, allows us to connect with SCM directly. Analog output 0~5V voltage. Quick response and recovery. RoboticsBD

Reference: RBD-2351

Brand: Hi-Link

HLK-LD2410C 24GHz mmWave 5M Human Presence Radar Sensor Motion Module

2 reviews

HLK-LD2410C 24GHz mmWave Radar Sensor for high-precision human presence detection. Detects motion, micro-motion, and stationary states up to 5 meters. Configurable detection range and sensitivity via Bluetooth or UART. Compact design with easy plug-and-play installation. Ideal for smart home, security, and automation applications.

Reference: RBD-1672

Tuya PIR Motion Sensor for Smart Life Wifi Based Alarm System

2 reviews

Model Number: P06 Product Name: PIR Sensor Indoor Communication: greater than 20 Meters Detect Angle Side View: 128 degrees Detect Angle Down View: 128 degrees Detect distance: 10 Meters<

Reference: RBD-2888

Heartbeat Detection Sensor

A sensor that allows you to measure your pulse with your finger using a phototransistor. The red LED lights up each time it detects a pulse. Powered by 5 V.

Reference: RBD-2780

M04 Non-Contact Liquid Level Detection Module Sensor

1 review

The M04 Non-Contact Liquid Level Detection Module Sensor offers reliable liquid level sensing without direct contact, ensuring convenience and accuracy in various applications. Designed for durability and refined performance, this module extends service life while providing accurate liquid level detection.M04 supports a wider range of 3.3-24V (Should Not...

Reference: RBD-3185

Dust/Air Purity Sensor PM1.0/PM2.5/PM10 - PMS7003 - 3.3V UART

The PMS7003 Dust Sensor is a highly precise module designed to monitor air quality by measuring particulate matter (PM) concentrations, including PM1.0, PM2.5, and PM10. This sensor detects particles as small as 0.3 µm, making it ideal for monitoring pollutants such as cigarette smoke and vehicle exhaust. Its compact design and advanced laser-based...

Reference: RBD-1022

High Sensitive Microphone Sound Sensor Detection Module

17 reviews

Main chip: LM393, Electret condenser microphone Working voltage: DC 3.3-5V Induction distance is 0.5M Signal output Indication Single channel signal output The output effective signal is low level.

Reference: RBD-2100

Flame Sensor Module Digital & Analog Output

18 reviews

Comparator chip LM393 makes module readings stable. Operating voltage 3.3V-5V. Fast Response Time Sensitivity adjustable Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm. Detection range: up to 100 cm. Adjustable detection range. Detection angle about 60 degrees, it is sensitive to the flame spectrum.

Reference: RBD-1172

Motion Sensor based LED Light Lamp Holder

5 reviews

Infrared Sensor Automatic Lighting Control Switch with lamp holder; convenient, safe & practical. Good solution for energy saving. You can conveniently let the light auto on/off. The switch can detect the human body's infrared, and use infrared to control the load. Easy to install. Strong anti-interference ability Suitable for corridor, toilet,...

Reference: RBD-2847

Magnetic Sensor to open Door/Window - Reed Contact CMD20

2 reviews

Wired proximity sensor activated magnetically. The device is used to determine the position of doors and windows. Case dimensions - 20 x 64 mm.