Reference: RBD-1038

PIC Development Board with Cable PIC16F877

Reset button.  4M crystal onboard, Using socket, Crystal frequency can be replaced easily at any time  4 independent push buttons, connected to RB0 RB1 RB2 RB3  8 LED's connected to the RD port, J3 is jumpered to enable LED. Remove to disconnect.  Standard RS232 communication interface, microcontroller computer communication interface. 

Reference: RBD-2230

NE555 Pulse Frequency Duty Cycle Adjustable Module Square Wave Signal Generator

Main chip: NE555 Input Voltage: 5V-15V DC. Generate an adjustable pulse for MCU. Generate an adjustable pulse, to control circuitry associated.

Reference: RBD-2089

Mercury Medallion Module

Consists of a mercury switch 680Ω resistor LED that will light up when tilt is detected. 

Reference: RBD-1582

TDA7492P Bluetooth 4.2 CSR8635 Bluetooth Receiver Amplifier Audio Board 2x25W for 4/6/8/16 Ohm Speakers Module Parts Component

25 W + 25 W continuous output power at THD = 10% with VCC= 20 V and RL= 8 Ω Wide-range single-supply operation (8 – 26 V) High efficiency (η = 90%) Four selectable, fixed gain settings of nominally 21.6 dB, 27.6 dB, 31.1 dB and 33.6 dB Differential inputs minimize common-mode noise Standby and mute features Short-circuit protection

Reference: RBD-0345

ESP-01 ESP8266 Serial WIFI Wireless Transceiver Module

802.11 b/g/n Standards Wi-Fi Direct (P2P), soft-AP 1MB Flash Memory Integrated low power 32-bit CPU could be used as an application processor A-MPDU & A-MSDU aggregation & 0.4ms guard interval Wake up and transmit packets in < 2ms Standby power consumption of < 1.0mW (DTIM3) RoboticsBD

Reference: RBD-0737

5V 1 Channel Solid State Relay (SSR)

Power supply:5VDC/160mA Switching Voltage (VAC):240@2A Isolation: Phototriac

Reference: RBD-1929

3.5inch HDMI Display-B

General-purpose HDMI display, Connecting computers, TV boxes, Microsoft Xbox360, SONY PS4, Nintendo Switch and so on Can be used as Raspberry Pi display that supports Raspbian, Ubuntu, Kodi, Win10 IOT, single-touch, free drive Can be used as PC monitor, support Win7, Win8, Win10 system (No touch Function)

Reference: RBD-0273

Brand: Waveshare

Arduino WIFI Shield EMW3162

A1rduino WIFI Shield EMW3162 (module is not included)

Reference: RBD-2150

Anti-Reverse Diode Constant Current Module 60V 10A For Backflow Protection

Type: Voltage Regulator Operating Temperature: -40-+85 Supply Voltage: 60v Dissipation Power: 10A Package: SMD

Reference: RBD-0189

Brand: DFRobot

Xbee Shield for Arduino (without Xbee)

Xbee Shield for Arduino (without Xbee) INTRODUCTION: The XBee Expansion Board is a compliant solution designed to meet low-cost, low-power wireless sensor networks with special needs.The module is easy to use, low power consumption, and the provision of critical data between devices reliable transmission.

Reference: RBD-0703

SSC-32 32Ch Servo Controller Lynxmotion Compatible

Controls up to 32 servo motors Comes preassembled USB interface (cable included), Xbee socket, and TTL serial Bidirectional communication with Query commands Large capacitors to prevent brownouts

Reference: RBD-1402

NodeMCU ESP8266 Expansion Base Board

The perfect solution for breaking out the pins from Lua V3 Nodemcu. Lead-out all the IO ports of the ESP-12E development board Lead out the pins of 5V and 3.3V power supply Convenient to connect with peripheral modules Onboard 5V / 1A DC-DC step-down converter circuit Onboard power indicator With DC power jack 6-24V.

Reference: RBD-2243

LilyPad Button Board

Wearable e-textile technology.  Designed with large sew tabs Button Board

Reference: RBD-0702

1 Channel 5V Relay Board Module

It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red) Relay control interface by single-chip IO. Low-level suction close, high-level release. Easy to use, simple 3 line structure. Note: Relay might be different from the picture as per stock

Reference: RBD-1912

L293D Motor Driver Module

New L293D motor shield, the input voltage DC4.5-25V 600mA output current capability per channel 1.2A peak output current(non-repetitive) per channel Enable facility Overtemperature protection Logical “0” input voltage up to 1.5V(High noise immunity)

Reference: RBD-0397

MCP2515 CAN Bus Module TJA1050 Receiver SPI Module For Arduino

Support CAN V2.0B technical standard, communication rate 1Mb / S. Module 5V DC power supply, SPI interface protocol control 0 to 8 bytes long data field. 8MHZ crystal oscillator 120Ω terminal resistance Use High-speed CAN transceiver TJA1050 Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation The...

Reference: RBD-2240

LilyPad SMD LED Green Color

Wearable e-textile technology.  Designed with large sew tabs LED Green Color

Reference: RBD-1759

Brand: Waveshare

E-Ink Electronic E-paper Display Screen Module 200x200, 1.54inch

Display Resolution: 200 x 200 Display Screen Color: Black and White No backlight so keeps displaying last content for a long time even when the power is down Ultra low power consumption, basically power is only required for refreshing SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.

Reference: RBD-1354

Jumper Wire Single 20cm

Length: 8 inches/20 CM (Long) Material: Copper Plated Pin Spacing: 2.54mm.

Reference: RBD-0699

1.8" inch TFT LCD Display module ST7735S 128x160

Display Size: 1.8″ Driver IC: ST7735 Input Voltage (V): 3.3 to 5 Pixel Resolution: 128 x 160 Interface Type: SPI

Reference: 1353

Jumper Wire Single 30cm

Length: 12.5 inches/30 CM (Long) Material: Copper Plated Pin Spacing: 2.54mm.

Reference: RBD-2241

LilyPad SMD LED White Color

Wearable e-textile technology.  Designed with large sew tabs LED White Color

Reference: RBD-2213

TPA3118 - 28p PBTL Mono Digital Amplifier Board 1X30W 12V Power Amplifier Module

Operating voltage (v):DC 8 – 12V Chipset:TPA3118 - 28 pin Chinese Variant Power output:30W Material:FR4 This is a Chinese variant of the TPA3118 in a 28-pin package.

Reference: RBD-1037

SIM808 GPRS/GSM+GPS Shield

Quad-band 850/900/1800/1900MHz Inner MT3337 GPS receiver, -165dBm precision, control on a same serial port. Earphone/ microphone outputs on a card or external 32-ohm speaker + supports voice calls with an electret microphone. Sending and receiving SMS.

Reference: RBD-2142

CH340C WIFI Module Adapter Download Debug for ESP8266 ESP-01/01S

Operating Voltage: 5VDC USB to Serial Converter: CH340C Compatible With:ESP8266 ESP-01/01S Comes With Onboard Reset Switch Has Female Headers for Connecting the Wifi Module.

Reference: RBD-2207

AD9850 DDS Signal Generator Module

2 sine wave and 2 square wave output. AD9850: 0-40MHz. After the 20-30MHz frequency harmonics increases, the waveform will be less and less clean. Low-pass filter with 70MHz, so the waveform better than SN. Parallel and serial data input can be selected via a jumper.

Reference: RBD-2076

5mm Two-Color LED Module

Operating Voltage:2.0v ~ 2.5v Current:10mA Diameter:5mm Color: Red + Green Beam Angle:150

Reference: RBD-0684

Motor Driver - Dual TB6612FNG (1A)

CW/CCW/short break/stop motor control modes Built-in thermal shutdown circuit and a low voltage detecting circuit Standby control to save power CW/CCW/short brake/stop motor control modes Operating Voltage(VDC): 15 Peak Current (A): 3.2 Continuous Current (A): 1.2 No. of Channels: 1

Reference: RBD-0981

MT8870 DTMF Audio Decoder Module

Low power device.  DTMF decoder chip.  Band-split filter. Digital decoding functions. Modem interfaces.  Mobile radios.

Reference: RBD-1349

16x2 Serial LCD Module Display for Arduino Assembled

For Standard LCD 16x2. Press here.For Standard LCD 16x2 with Male Header. Press hereFor Standard LCD 16x2 with Female Header. Press hereFor Standard LCD 16x2 with I2C adapter board soldered. Press here.For Standard LCD 16x2 with White Background. Press here.For Standard LCD 16x2 with Blue Background. Press here. Model: LCD1602 Interface: I2C Interface...